VASULKA.ORG
Steina Home
 Works by Steina 
 Geomania    
frontpage image
   articles / notes technical description photo documentation movie   
 
T H E   S P A C E
The minimum active space required is 10 meters by 7.5 meters by 3.5 meters high, or 35 feet by 25 feet by 12 feet high. The major consideration in terms of space is the total avoidance of ambient light. The space should be painted a non-reflective black and no light source should exist, other than the one that emanates from monitors themselves. Also include a low bench seating four or five people. The entrance must be well insulated from light and sound. Most ideal is a double trap door with sound insulating material. (See entrance diagram.)
 
E Q U I P M E N T
The Vasulkas can provide all the equipment listed below, or share resources with the exhibitor. This will be reflected in both shipping and equipment budgets.
  10 stackable matching video monitors
2 Pioneer Video Laser Disk Players, LD-V Series
2 program video laser disks, NTSC, color
1 two-channel synchronizer
2 stereo audio amplifiers (4 audio channels)
4 speakers (internal speakers of superior quality may be used)
4 speakers stands or wall mounts
10 video cables approx. 3 feet (1 meter) long each
2 pairs of stereo cables
4 speaker cables
15 power outlets
NOTE: The laser disk synchronizer used by the Vasulkas is custom built and interfaces only with Pioneer Industrial Laser Disk Players (2200 to 8000 Series). It is not interchangeable with laser disk players from other manufacturers, such as Sony and Phillips, which require a commercially available synchronizing device.
 
V I D E O   M O N I T O R S   A N D   M O N I T O R   P L A T -
F O R M S
The ten (15, 21) monitors must be matching in size and manufacture. They should be stacked in a pyramid fashion on four square platforms one foot (30 cm) high or a single low bench. The platforms must be custom-made to the size and shape of the monitors. The auxiliary equipment (players, amplifiers, synchronizer) should be located inside these platforms.
 
M O N I T O R   M A T R I X   W I R I N G
The matrix is pyramid configured and wired in the following manner.
 
 
A U D I O   W I R I N G
Use internal speakers or connect the two stereo cables from each player to the two amplifiers, and the four speaker cables to the speakers. The speakers should be hung on the walls at equal distances.
 
S O U N D   A N D   I M A G E   A D J U S T M E N T
Treble should be normal and bass at maximum. All 75 ohm terminators located on the back of the monitors must be switched to open, except for the last monitor on each chain. Contrast should be high and brightness below middle. The basic rule here is to set up the proper deep color black as a reference to the maximum contrast and brightness. With that, the other components (hue, color saturation) can be assigned. The persons installing the environment must use their esthetic judgment as to the proper monitor settings for maximum visual impact.
 
D A I L Y   O P E R A T I O N S
TO START:
Power up the monitors, disk players and synchronizer. Wait a while to verify that the installation is starting synchronously. If not, turn power off and on again for the players and synchronizer. If problem persists, contact Steina by phone, fax, or e-mail.

TO SHUT DOWN:
Turn power off the monitors, disk players, and synchronizer.

MAINTENANCE:
The monitor screens need to be cleaned with a soft cloth at least once a week.

 
P O W E R   R E Q U I R E M E N T S
 
(depending on equipment used)
Video monitors:
Stereo amplifiers:
Video disk players:

Synchronizer:

Sony PVM 1910

Pioneer 2200
Pioneer 8000
Jericho Data Systems

120 watts
150 watts
70 watts
100 watts
40 watts
Outside USA, use a Power Transformer 220 to 110, 1000w.
 
S H I P P I N G   I N F O R M A T I O N
Installation is shipped in four crates. Weight and dimensions available upon request.